Photo 25-04-2017, 10 46 06

The drawer fronts have been angled on one side, and the bottom edge beveled off. The edges were lined up against the closed drawers, held in place, the drawer opened and clamped in place.

The drawers had pilot holes drilled in using a template to ensure that each drawer had the same positioning. These where then countersunk to the diameter of the screw head.

Using a compact mini hand drill i screwed in at an angle from inside the drawer, through the false front, and into the drawer front, using 25 mm screws.

Photo 25-04-2017, 09 52 22

Advertisements